Add dragon-scale detail to your dog’s collar with a pattern I tool into heavyweight leather by hand, then finish with two contrasting dye colours. Each collar is made to order in my Kent workshop, with natural grain and variations in the dyed finish making every piece slightly different. Choose Blue & Green, Red & Tan or Black & Grey. The collar is 25mm wide, with solid brass hardware and five buckle holes for adjustment. Three sizes are available: Small has an adjustment range of 267–343mm, Medium 343–419mm and Large 419–495mm. Choose from these measurements when ordering rather than relying on a breed or general size label. To measure, use a soft tape around your dog’s neck, leaving enough room for two fingers between the tape and your dog. Alternatively, lay a well-fitting collar flat and measure from the middle of the buckle pin to the hole normally used. Do not use the collar’s full end-to-end length as the neck measurement. If you are unsure which size to choose, or would like an exact measurement or another dye pairing, please contact me before ordering. One collar is supplied; photographs showing more than one collar compare the colour options. Please allow 5–7 working days for me to make your collar before dispatch.
Choose Small (267–343mm), Medium (343–419mm) or Large (419–495mm), then Blue & Green, Red & Tan or Black & Grey. For another colour pairing or an exact measurement, please contact me before ordering. Available dyes: Black, Brown, Slate Grey, Tan, Red, Green and Blue. No initials or lettering are offered on this design.
